Publicité
Les langues disponibles
Les langues disponibles
„
„
Lift the panel at the back of the appliance and screw the blender shaft (E) anti-clockwise
without forcing it until you hear a click (fig.8). If you feel resistance when screwing in, this
means that the shaft is not correctly aligned. You should remove it completely and
screw it in again correctly.
„
„
Connect the appliance: Dip the blender shaft into the preparation before starting the
appliance to avoid splashing (Fig.11). Start using the Eject button (A1) (Fig.11). Stop the
appliance before removing the blender shaft from the preparation (to avoid splashing).
„
„
Removing the blender shaft: Stop the appliance by selecting "0", disconnect it and
unscrew the blender shaft (E) by turning clockwise (Fig.12).
„
„
Do not use the blender shaft: In a container on a heat source. Do not use it empty or with
ice cubes, to chop raw meat, dried fruit (almonds, hazelnuts, etc.).
Mini-chopper function 150ml H (depending on model)
Check that the appliance is unplugged, that the speed control (A2) is set to "0" and that the
beaters or kneaders have been removed from the appliance.
„
„
Assembly : place the blade unit (H2) on the bowl (H1) (fig. 14).
„
„
Use : Place the food in the bowl (H1) then fit the lid centre (H3), then the lid (H4). Connect
the motor unit to the mini chopper (H) (fig. 15) and press the Start or Turbo button (A1)
(fig. 11). After use, remove the food.
„
„
Dismantling : Be careful not to touch the sharp blades when dismantling the appliance.
Remove the motor unit, then the lid (H4) and then the lid centre (H3). Remove the blade unit
(H2) taking it by its plastic part as it is extremely sharp. Do not use this appliance for over
10 seconds if it is empty.
„
„
Cleaning : the blades are very sharp. Always unplug the appliance before cleaning it. Never
put the mini chopper lid in the dishwasher. (H4) (fig. 17). Never immerse these parts in water
or place them under running water. Clean them with a damp sponge. (fig. 18). The other parts
of the mini chopper (H1, H2 and H3) are dishwasher friendly (fig. 19). You may wash the body,
the blades and the blade holder with a moist sponge and some washing-up liquid.
Unplug the unit
„
„
Then press the accessory eject button (A1) to release the whisks or mixers.
10
Publicité
