Expondo STAMOS S POWER 2 S-CUTTER 50 Manuel D'utilisation page 16

MOSFET:
This inverter uses MOS-FET technology. More than any other
technology, the MOS-FET enables the achievement of maximum
effectiveness. In comparison to the amount of electricity used
the user will obtain disproportionate effectiveness. The result is
an efficiency of 93%! Therefore the current is kept constant and
ensures a perfect weld. Only by using the MOS-FET technology
is it possible to keep this device as compact and lightweight.
NORMAL CURRENT:
The device uses a 1-phase connection (230V +/- 10%).
1 PH
ACCESSORIES S-CUTTER 50:
1. Plasma torch PT-31 - 5m.
2. Grounding clamp cable - 3m.
3. Electrode 1 pcs.
4. Nozzle 1 pcs.
5. Gas hose with clips.
EN
ZUBEHÖR S-CUTTER 70:
1. Plasma torch P60 - 5m.
2. Grounding clamp cable - 3m.
3. Electrode 1 pcs.
4. Nozzle 1 pcs.
5. Gas hose with clips.
Rev. 26.04.2019
30
S- CUTTER 70 3PH Connection scheme:
S- CUTTER 70 3PH / S-CUTTER 90 power supply:
HIGH POWER: These devices use a 3-phase connection (400V
+/- 10%).
3 PH
The yellow-green wire is used as a PE protective wire connec-
tor. The three phases (black) can be freely connected to L1, L2
and L3 (please have it done only by a qualified electrician).
Rev. 26.04.2019
EN
1 – plasma torch
2 – workpiece
3 – earth clamp
4 – manometer
5 – air compressor
31