Remove the EasyClick blade insert
6.
from the blender jug.
→ Fig.
29
Clean the components.
7.
Cleaning the To-Go blender
jug and To-Go blade insert
ATTENTION!
The blender knife has sharp blades.
Improper handling may damage the
blades or the surface.
Never set the blade insert down
▶
with the blade facing downwards.
Turn the To-Go blade insert anti-
1.
clockwise and remove it from the
To-Go blender jug.
→ Fig.
30
Turn the lid anti-clockwise and re-
2.
move it from the To-Go blender
jug.
→ Fig.
31
Open the mouthpiece on the lid.
3.
→ Fig.
31
Remove the seal.
4.
→ Fig.
31
Clean the components.
5.
Using the cleaning pro-
gramme
You can use the cleaning pro-
gramme to preclean the blender jug
and the blade insert.
Recipes
Recipes
You can find a selection of recipes specially developed for your appliance here.
Recipes
Overview of recipes
This overview lists the ingredients
and processing steps for various re-
cipes.
→ Fig.
33
Requirements
¡ The blade insert is installed.
¡ The blender jug has been attached
and locked.
¡ The blender jug is filled with clean-
ing fluid (700 g water + 1 drops of
washing-up liquid).
¡ The lid is attached and locked.
¡ The rotary switch is set to .
Set the rotary switch to .
1.
→ Fig.
8
a The status display (LED) on the
rotary switch lights up.
Press the programme button
2.
→ Fig.
11
a While the programme is running,
the LED for
status display (LED) goes out.
Wait until the appliance stops.
3.
Set the rotary switch to .
4.
Turn the blender attachment anti-
5.
clockwise and remove it from the
base unit.
→ Fig.
16
Turn the lid in the direction
6.
remove it.
→ Fig.
32
Dispose of the cleaning fluid.
7.
a The most stubborn food residues
are removed.
Clean the components.
8.
For the recipes labelled with (*) in the
recipe table, leave the appliance to
cool to room temperature after
three operating cycles.
Recipes en
lights up and the
and
37
.