Specifications - Kenwood KDC-X500 Mode D'emploi

TROUBLESHOOTING
Symptom Remedy
• Adjust the microphone unit's position. ( 15)
Echo or noise is heard during
• Check the [ECHO CANCEL] setting. ( 17)
a phone conversation.
• Reduce the distance between the unit and the Bluetooth device.
Phone sound quality is
• Move the car to a place where you can get a better signal
poor.
• Use voice calling method in a more quiet environment.
Voice calling method is not
• Reduce the distance from the microphone when you speak the
successful.
• Make sure the same voice as the registered voice tag is used.
• Reduce the distance between the unit and the Bluetooth audio
Sound is being interrupted
or skipped during playback
• Turn off, then turn on the unit and try to connect again.
of a Bluetooth audio player.
• Other Bluetooth devices might be trying to connect to the unit.
• Check whether the connected Bluetooth audio player supports
The connected Bluetooth
audio player cannot be
controlled.
• Disconnect and connect the Bluetooth player again.
"DEVICE FULL" The number of registered devices has reached its limit. Retry after
deleting an unnecessary device. ( 19, DEVICE DELETE)
"N/A VOICE TAG" Make sure the same voice as the registered voice tag is used.
"NOT SUPPORT" The connected phone does not support Voice Recognition feature or
phonebook transfer.
"NO ENTRY" / "NO PAIR" There is no registered device connected/found via Bluetooth.
"ERROR" Try the operation again. If "ERROR" appears again, check if the
device supports the function you have tried.
"NO INFO" / "NO DATA" Bluetooth device cannot get the contact information.
"HF ERROR XX" / Reset the unit and try the operation again. If this does not solve the
"BT ERROR" problem, consult your nearest service center.
28
reception.
name.
player.
Audio/Video Remote Control Profile (AVRCP). (Refer to the
instructions of your audio player.)

SPECIFICATIONS

FM Frequency Range
Usable Sensitivity
(S/N = 26 dB)
Quieting Sensitivity
(DIN S/N = 46 dB)
Frequency Response
(±3 dB)
Signal-to-Noise Ratio
(MONO)
Stereo Separation (1 kHz)
AM Frequency Range
Usable Sensitivity
(S/N = 20 dB)
Laser Diode
Digital Filter (D/A)
Spindle Speed
Wow & Flutter
Frequency Response (±1 dB)
Total Harmonic Distortion
(1 kHz)
Signal-to-Noise Ratio (1 kHz)
Dynamic Range
Channel Separation
87.9 MHz — 107.9 MHz
(200 kHz space)
8.2 dBf (0.71 μV/75 Ω)
17.2 dBf (2.0 μV/75 Ω)
30 Hz — 15 kHz
64 dB
40 dB
530 kHz — 1 700 kHz (10 kHz space)
29 dBμ (28.2 μV)
GaAIAs
8 times over sampling
500 rpm — 200 rpm (CLV)
Below measurable limit
20 Hz — 20 kHz
0.01 %
: 110 dB
/ :
105 dB
90 dB
85 dB