Kenwood KDC-X500 Mode D'emploi page 20

BLUETOOTH®
Connect with a remote device by One-touch
(NFC)
(for )
Near Field Communication (NFC) enables short-range
wireless communication between the unit and remote
devices.
By holding an NFC-compatible remote device near
to the N-Mark on the unit (volume knob), the unit
and remote device proceed to complete pairing and
established the BLUETOOTH connection automatically.
1
Activate the NFC function on the remote device.
Refer to the instruction manual of the remote device
for more information.
2
Hold the remote device near to the N-Mark on the
unit (volume knob).
The device vibrates when pairing is completed.
• To disconnect, hold the remote device near to the
N-Mark on the unit (volume knob) again.
• This unit only can recognize and connect to one NFC-
compatible device at a time.
16
BLUETOOTH — Mobile phone
Receive a call
When there is an incoming call:
• The unit answers the call automatically if [AUTO ANSWER] is set to a selected time. ( 17)
During a call:
• The buttons and display illuminate according to the settings made for [DISPLAY]. ( 23)
• If you turn off the unit or detach the faceplate, the Bluetooth connection is disconnected.
The following operations may differ or not available depending on the connected phone.
To
First incoming call...
Answer a call
Reject a call
End a call
On the faceplate
Press or the volume knob
or one of the number buttons
(1 to 6).
Press .
Press .
On the remote control
Press .
Press .
Press .