Outside Living Industries sunwater NORTLAND Notice De Montage page 8

WARRANTIES - After-sales service
Swimming pool 300x490 - H120 cm
Warranty conditions:
The swimming pool must be assembled within 48 hours of the package being opened.
For the warranty to be valid, a concrete slab must be in place.
Our warranty covers only the replacement of defective parts. It in no way covers demands for compensation or damages. The general warranty does not apply in the following circumstances:
• Use of the equipment in a way which is not in accordance with the instructions.
• Damage incurred as a result of bad handling during and after assembly. or any changes made to structural elements without the manufacturer's agreement
1) Pump : 2 year warranty (electrical problems) under normal conditions of use. The following are not covered by the warranty: damage due to abrasion or corrosion (particularly in the case of treating the water by
salt electrolysis), damage due to a faulty connection, equipment dismantled or repaired by a third party, breakage of parts (pump stand, pre-filter cover, grooved end fitting), using the pump when it is empty or
immersing the pump (e.g. if the pump house is flooded). The warranty is not valid if the electric cable and/or the plug are replaced, removed or damaged.
2) Liner : 2 year warranty under normal conditions of use. The following are not covered by the warranty: rips, holes, tears, stains (treatment products put straight into the water) stains related to the development
of algae, stains related to decomposing foreign bodies in contact with the liner, stains and discolorations resulting from the impact of oxidising products, discoloration and wear due to materials rubbing on various
surfaces. Distortions in the liner if it has been out of water for more than 24 hours (never completely empty your pool). See the warranty document that comes with the liner.
3) Filter : 2 year warranty under normal conditions of installation and use: tank, drain plug, collar and multiport valve.... The following are not covered by the warranty: problems with waterproof sealing due to
operating at a level of pressure which exceeds the maximum pressure permitted (see instructions for the filter).
4) Skimmer : 2 year warranty on the waterproof seals.
5) Wooden structure : 10 year warranty against rotting and damage caused by insects. The following are not covered by the warranty: changes in the colour of the wood caused by the climate, natural distortions
(splits, cracks, knots and minor flaws in the tongues of the planks which do not have any adverse effect on the mechanical strength of the wood or on the assembling of the pool). The warranty does not cover incor-
rect assembling or storage which may cause the wood for the sides of the pool to become warped (assembling the pool a long time after contents have been taken out of the packaging) or distortion of the planks
by the pressure of the water, which does not have any detrimental effect on the mechanical resistance of the pool. Any additional protection of the wood for the structure can only be undertaken using a product
which is compatible with autoclave treatment.
IMPORTANT : The after-sales service will be available only at point of sale.
Essential records for claiming the warranty:
- Till receipt / proof of purchase.
- Photograph of the damaged part or the problem in question
Shop :
City :
Contact department :
Direct tel :
Code Ref. Désignation
M-1 7504305 Plank 45x145x1480
M-2 7514281 Plank 45x145x1580
M-3 7514282 Plank 45x145x3080
MS-C 7514283 Upper plank 45x135x1580
MS-L 7514284 Upper plank 45x135x3080
2MS 7504306 1/2 upper plank 45x67x1480
2MI-C 7514285 1/2 lower plank 45x77x1580
2MI-L 7514286 1/2 lower plank 45x77x3080
MSS 7514287 Upper skimmer plank 45x135x1580
MIS 7514288 Lower skimmer plank 45x145x1580
MR 7504328 Water jet plank 45x145x1480mm
7514114 Sacrifice part 45x135x280mm
PF 7514113 L-section finish 28x70x1260
C 7514048 Console edging 45x230x170
7514049 Wooden stop block for the skimmer flap 30 x 20 x170
PR 7514097 Post 45x135x1275mm (reinforcement)
L 7514096 Dressing lath 22x165x1275
PL 7100201 Pair of rungs for wooden ladder H120/130
T 7514052 Wooden ladder steps/Simmer flap 28x145x600mm
MSD 7514289 Pine outer right skimmer edging 28x145x426mm
MSG 7514290 Pine outer left skimmer edging 28x145x426mm
MGI-P 7100208 Pine edging 28x145x1219 int.
MGE-P 7100209 Pine edging 28x145x1343 ext
MGI-M 7514291 Pine edging 28x145x1329 Int.
MGE-M 7514292 Pine edging 28x145x1453 ext.
MGE-L 7514293 Pine edging 28x145x2953 ext.
MGI-L 7514294 Pine edging 28x145x2829 int
BM-H 7514832 IPE 120 galvanised cradle - 2966 mm
BM-V 7514012 Complementary IPE 120 galvanised cradle - 1294 mm
7514214 Bag of 12 metal cradle bolts
7514149 Bag with sand (25 Kg)
R 7514016 Hung 2,06 m hanging rails
7514750 3-step stainless steel ladder
Poolmax pump
Filtration
8m long cuttable hose
S Skimmer, large
JM Anodised aluminium joint
Ground protection felt
Protection felt for wall
NOTICE 300x490 - H120-2018/1 Sunwater new.indd 9
- Warranty filled out correctly.
- Reference number of the faulty part.
Client :
Address :
City :
Tel :
Qty Qty
Hardware kit
7514696
parcel ASS
Code Ref. BREAKDOWN OF THE HARDWARE KIT
31
13
A2 7514606 Console + reinforcer bag
14
B 7514270 Cradle masking bag
1
C3 7514616 Rail bag - Hung
2
DMI 7514553 Edging screw bag
4
DMP2 7514618 Edging screws bag
2
E 7514145 Skimmer door bag
2
1 F 7514620 Jointing curb bag alu
1
G 7514146 Wood ladder + finishing section bag
1
2
16
20
2
14
2
1
5
MGI-P
1
1
MGE-P
4
4
2
1
2
2
1
2
1
2
7
1
1
MGI-M
1
1
1
8
2
1
8
7504214
1
Qté Qté
parcel ASS
7504221
3
1
7514926
1
1
1
1
1
1
PL
MGE-L
MGI-L
MSS
MIS
PR
MS-L
M-1
II / 18-I
Liner 75/100 bleu 335x485 H120 cm 1
or
Liner 75/100 beige 335x485 H120 cm 1
or
Liner 75/100 grey 335x485 H120 cm 1
T
MS-C
M-2
BM-H
BM-V
2MI-C
PR
PR
M-3
2MI-L
09.01.18 08:41