Goobay 39510 Mode D'emploi page 17

Fig. 9: Mounting rotor
(4)
Fig. 10: Mounting protective net
Fig. 11: Mounting Carrier halves
Fig. 12: Hooking the protective net basket into the carrier
2. Slide the rotor (6) with the spacer
in the direction of the motor onto the
axis.
The rotor must not rest directly on the
motor. There must be a visible distance
between the spacer and the motor.
Moto See Fig. 9 a).
3. Tighten the rotor with the screw on the
side of the spacer. See Fig. 9 b).
4. Place the front half of the protective net
on the protective net with motor and
rotor.
The holes of both halves must be on top
of each other. See Fig. 10 a).
5. First insert all Phillips-heads screws (5)
through the holes provided in both
halves of the net.
6. Then tighten the screws clockwise
in diagonal order, Fig. 10 b).
Otherwise the grid may warp.
7. Plug the two carrier halves (1)
together as shown in Fig. 11 a).
8. Tighten it with the Phillips-head screw
with lens head (2). See Fig. 11 b).
17