Publicité
8. The display will return to the Run screen, with the job name displayed at the
top. At this time, you should set the cutter depth knob (Figure 4-10) for the
desired cut. Position 1 is the shallowest cut, and 3 is the deepest.
9. Once ready to begin, use the arrow buttons to highlight Run, and then press
Enter to start the machine (Figure 4-11). The screen will display "RUN
MODE ACTIVE" and elapsed run time.
40
OMATION® Series 410 Envelopener™ Operator Manual
Figure 4-10: Setting the cut depth
Figure 4-11: Starting the machine
OPEX Corporation
No Cut
Select RUN,
then press Enter
3
2
1
Operation
Publicité
Chapitres
