Publicité
4.1.2.3. PRINT
In jobs that have printing enabled, this will be set to ON. This will allow the
operator to temporarily turn audit trail printing off and on. This capability was
provided in case there is an issue with the printer and the operator wants to run
mail without correcting that issue. Printing cannot be turned on if running the
No Print job.
Note: When turning printing back on, the machine will ask if you want it to
"spit". This means the printer will spray a small mark, as a quick way to clear
the print nozzles. You should have a piece of paper under the print head when
doing this.
4.1.2.3.1. Print Head Cleaning
The SPIT option appears before ON when cycling through the print options. This
sprays ink from the print nozzles as a way to clean the heads of the cartridge.
The print nozzles can be cleaned by placing a piece of paper under the print
head selecting SPIT, and pressing the down arrow.
4.1.2.4. ZERO COUNT
This will allow the user to reset the statistics counters for the current run. At the
beginning of a run or at any point during a run, a user may reset the counters.
This will cause the software to zero all of the counts on the screen, close out
the current statistics "record," and open up a new one.
4.1.2.5. STATISTICS
This will show the DISPLAY STATISTICS screen, which will allow the user to
display and optionally print their statistics (Figure 4-3).
Operation
OMATION® Series 410 Envelopener™ Operator Manual
Figure 4-3: Display Statistics screen
OPEX Corporation
35
Publicité
Chapitres
