Velleman VTSS230 Mode D'emploi page 8

7.2 Setup
Do not force the nozzle or pull its edges with pliers.
1. Make sure the appliance is switched off and the iron/air gun is completely cooled
down.
2. Select the air nozzle and slide it onto the air gun.
3. Plug in the power cord and switch on the station.
4. Select the temperature and airflow.
5. Wait until the temperature is stable.
8. Cleaning and Maintenance
8.1 General
Only perform the maintenance as described in this user manual. Contact an authorised
dealer or service agent for any other maintenance or repair.
If the iron or station becomes faulty or, for some reason does not operate normally,
return it to the service department of your authorized dealer or service agent.
Clean the outer cover of the iron and station with a damp cloth and a small amount of
liquid detergent. Never submerge the unit in liquid or allow any liquid to enter the case
of the station. Never use any solvent to clean the case.
Use only original replacement parts.
8.2 Storing
Store the appliance, its accessories and this user manual in the original packaging.
Always store in a cool and dry place.
9. Technical Specifications
power supply ............................................................................. 220-240 V~, 50 Hz
power
soldering iron.................................................................................... 24 V, 60 W
hot air pump ........................................................................................... 300 W
temperature range
soldering iron............................................................ 50 ~ 480 °C (122 ~ 896 °F)
hot air pump .......................................................... 100 ~ 500 °C (212 ~ 932 °F)
V. 04 – 29/01/2021
VTSS230
8 ©Velleman nv