Velleman VTSS230 Mode D'emploi page 6

3. General Guidelines
Refer to the Velleman
All modifications of the device are forbidden for safety reasons. Damage caused by user
modifications to the device is not covered by the warranty.
Only use the device for its intended purpose. Using the device in an unauthorised way
will void the warranty.
Damage caused by disregard of certain guidelines in this manual is not covered by the
warranty and the dealer will not accept responsibility for any ensuing defects or
problems.
Nor Velleman nv nor its dealers can be held responsible for any damage (extraordinary,
incidental or indirect) – of any nature (financial, physical...) arising from the possession,
use or failure of this product.
Keep this manual for future reference.
4. Overview
Refer to the illustrations on page 2 of this manual.
1
2
3
4
5. Installation
1. Install the appliance on a flat, stable and fire-resistant surface.
2. Make sure that the power switch at the back of the appliance is in the off
position (0).
3. Connect the soldering iron to the appliance.
4. Plug the power cord into a suitable, earthed mains outlet.
6. Operation
6.1 General Operation
1. To switch on the appliance, set the power switch in the on position (I). The device
starts heating up, the temperature and airflow values will be displayed.
2. Switch on the soldering or rework station with the respective button.
3. Select the temperature unit with the temperature unit setting switch.
Set the temperature and airflow value with the respective + and – buttons and the
4.
airflow control knob.
5. After setting, wait for the values to stabilize before starting to solder.
V. 04 – 29/01/2021
®
Service and Quality Warranty on the last pages of this manual.
soldering station display +
temperature setting button
airflow control
soldering station on-off switch
soldering station connection
VTSS230
5
6
7
8
6
rework station display +
temperature setting button
temperature unit setting
rework station on-off switch
rework station connection
©Velleman nv