Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Preparing the antenna module for operation
Connecting the antenna module to the mains power
supply
The antenna module is powered from the ADN CU1 central unit via the
SBC CBL RJ45 system cable.
CAUTION
Product damage due to an unsuitable power supply!
If you use an unsuitable power supply, this can cause damage to the
ADN-W AM antenna module.
2
6cc|ccADN-W AM
If the power supplied via the system cable is not sufficient and
if the antenna module is not listed in the central unit's oper-
ating menu under
"System
Version
Info" or
"Software Version
Main menu
System menu
Versions
Use the optional NT 12-50C power supply.
Only connect the NT 12-50C power supply to the antenna module.
Connect the hollow jack plug
5
the hollow jack socket
EU
UK
US
3
Pass the cable through the cable grip
Connect the Euro 8 connector of the mains cable to the socketc
the NT 12-50C power supply.
Connect the mains plug of the mains cable to a wall socket.
Menu" > "Versions" >
Info":
Software Version Info
Hardware Version Info
CU1 SB:
1
ADN PS:
1
AM
1
2
of the NT 12-50C power supply to
.
2
NT 12-50C
2
as shown.
"Hardware
No
5
3
of
Publicité
Chapitres
Table des Matières
