Rear Panel; Front Panel - M-Audio BX3 Guide D'utilisation

Features

Rear Panel

1. Rear Port: The rear port enhances the
bass generated by the woofer, increasing
the low frequencies. Make sure these
ports are not obstructed since this will
adversely affect bass response.
2. RCA Inputs: Use the included audio cable
or other RCA cables (sold separately) to
connect external sound sources to these
inputs.
3. 1/4" (6.35 mm) TRS Inputs: Use 1/4"
(6.35 mm) audio cables (sold separately) to
connect external sound sources to these
inputs.
4. 1/8" (3.5 mm) TS Output to Passive
Speaker: This is the audio connection to
the passive speaker. Use the included 1/8"
(3.5 mm) TS interconnection cable to
connect the active speaker to the passive
speaker.
5. 1/8" (3.5 mm) TS Input from Active
Speaker: Use the included 1/8" (3.5 mm)
TS interconnection cable to connect the
active speaker to this passive speaker.
6. Active Speaker Position: Adjust this to set the position for the active speaker in the stereo field.
This allows you to choose to have the active speaker on either your left or right depending on
your preferences and where your connections are.
7. High EQ: Turn this knob to boost or cut the high-frequency equalization of the speakers.
8. Low EQ: Turn this knob to boost or cut the low-frequency equalization of the speakers.
9. Power Connector: Plug the included 2-prong IEC power cable here.

Front Panel

1. Tweeter: This outputs the high frequencies.
2. Woofer: This outputs the low frequencies.
3. 1/8" (3.5 mm) TRS Aux Input: This stereo
1/8" (3.5 mm) TRS input can be used to
connect an MP3 player or other audio
source.
4. Headphones: Connect your 1/8" (3.5 mm)
headphones to this output to hear the mix
through your headphones. Note that while
headphones are connected to BX3, you
will not be able to hear sound out of your
speakers until
disconnected.
5. Vol/Power: This knob is used to turn the speakers on and adjust their volume. To turn on,
simply turn up the knob. You will feel a click when the speakers turn on. An LED on the speaker
will illuminate. To turn off, simply turn the volume all the way down; the LED will turn off to let
you know that the speakers are off.
the headphones
2
3
4
7
8
6
Tip/Hot
Ring/Cold
Sleeve/Ground
TRS
Connector
3
are
4
1
9
1
2
5
1
5
Tip/Signal
Sleeve/Ground
TS
Connector
1
2
5