Gima TD001P-3 Notice D'utilisation page 5

5
PURCHASE ACKNOWLEDGEMENT
Thank you for the trust placed in the purchase of our product and we are certain that you will always be
satisfied with any of our products.
For better service of all your questions and needs, customer service is at your disposal to solve any query:
PRODUCT DESCRIPTION
a. Main body
b. Front base
c. Rear base
d. Handle bars
SAFETY WARNINGS
• These instructions are very important. Please read this instructions ma-nual carefully before using
the appliance and keep it at hand to refer to it at any time.
• No responsibility is assumed for the improper use of the product, or any other use that is not described in
this manual
• Before using the product for the first time, unpack the product and check that it is in perfect conditions.
If not, do not use the appliance and contact, as the guarantee covers any damage from origin or
manufacturing defects.
• This product is only indicated for domestic use. Do not use the appliance outdoors. Never leave
the appliance exposed to climatic agents such as rain, snow, sun, etc.
• This appliance can be used by children of 8 and more years old as well as by disable people, people with
reduced sensorial o mental capacities, people with lack of experience and knowledge, if the appropriate
supervision and instruction of use was provided them in reliable way and they understand danger it entails.
The cleaning and maintenance allow to be realized by the user, must no be realized by the children, only in
case they are more than 8 years old and only under supervision.
• Keep the appliance out of reach of the children younger 8 years old.
• Children should be supervised to ensure they do not play with the device.
• Do not immerse the appliance in water or any other liquid.
• Do not mix new batteries or the old and worn-out.
ASSEMBLY
1. Unfold the front and the rear bases till it sounds a "click". It means that the structure is properly attached
in order to practise the exercise. Before doing any exercise, please check both bases are properly fixed
(as fig. 1).
2. Place the display unit into its gap. Note that the wire must be properly -placed inside (as fig. 2).
3. Place the intensity regulator screw into its slot, placed on the top part of the mini exercise bike.
INSTRUCTIONS FOR USE
This pedaler has 5 different functions:
• CNT – COUNTER: Total of laps done with the device during this training session.
• TIME: Counts the effective exercising time during this training session.
• CAL - CALORIES: Calories burnt during the exercise.
• RPM - Revolutions per minute: It shows the average of laps per minute based on the intensity of the pedal
exercise.
• SCAN It shows the other functions every 5 seconds in turn.
• Before starting the exercise, place the device on a flat surface and adjust the pedaling resistance
according to the strength desired for the exercise (h). In order to obtain more resistance, turn the dial
counterclockwise.
1. Press the red button located in the counter (g) or start pedaling. In this way the counter (g) will be started.
• The word STOP will appear at the display when you stop pedaling and it will disappear when you renew
the exercise.
• The display turns off in a few minutes after you stop pedaling.
2. To check the results obtained with the exercise read carefully the following procedure:
e. Right pedal
f. Left pedal
g. Counter and battery compartment
h. Effort regulator
ENGLISH