Publicité
Les langues disponibles
Les langues disponibles
CONTROLS
Up on the right (see fig. 1 on page 3), cabinets are fitted with a switch for the control of product lighting and with a
thermometer for the visualization of the temperature. On the roff cabinets are fitted with a rempte thermostat for tem-
perature control. The remote thermostat displays the temperature existing inside the case and allows temperature con-
trol by the use of the appropriate keys.
WARNING: Adjustment is reserved for the technical personnel.
SHELVES: the shelves were designed to bear a maximum load of 225 kg/sq.m. Shelf inclination can be set on 4 dif-
ferent positions (0° - 7° - 14° - 21°), by moving the shelf supporting bracket on the display case's uprights.
9. PRESCRIPTIONS AND RESTRICTIONS
Keeping pharmaceutical products in the display case is strictly forbidden (fig.10).
Do not remove protections or panels when it requires the use of tools. IN PARTICULAR, DO NOT REMOVE THE ELEC-
TRIC CONTROL BOARD COVER AND THE SCREWS FASTENING SHELF LIGHTING PLUGS.
Do not expose the display case to atmospheric agents (fig. 15). DO NOT STEP on the cabinet bumper rail. DO NOT
STEP on the top of the cabinet and DO NOT LAY WEIGHTS on it.
Do not spill water directly or indirectly on the display case (fig. 13). Do not touch the equipment with damp or wet
hands or feet; do not use it while barefoot (fig. 14).
ANY OTHER USE NOT EXPRESSLY MENTIONED IN THIS BOOKLET MUST BE CONSIDERED AS HAZARDOUS.
THE MANUFACTURER ASSUMES NO RESPONSIBILITY FOR ANY DAMAGE RESULTING FROM IMPROPER,
INCORRECT OR UNREASONABLE USE.
The installation of the appliance and the refrigerant condensing unit must only be made by the manfacturer's
service personel or similarly skilled person.
The information provided with an appliance with a separate refrigerant condensing unit shall include:
- information on the type of separate refrigerant condensing unit to wich the cabinet shall be connected;
- an electrical diagrams showing the electrical terminals for connections.
THE INSTRUCTIONS CONCERNING PERSONS (INCLUDING CHILDREN) WITH REDUCED PHYSICAL, SEN-
SORY OR MENTAL CAPABILITIES, OR LACK OF EXPERIENCE AND KNOWLEDGE AND CHILDREN PLAYING
WITH THE APPLIANCE ARE NOT REQUIRED
10. ORDINARY MAINTENANCE
ATTENTION! BEFORE STARTING ANY MAINTENANCE OR CLEANING, DISCONNECT THE EQUIPMENT
FROM THE ELECTRICAL POWER SUPPLY USING THE MAIN WALL CUT-OFF SWITCH (fig. 17).
IMPORTANT: During maintenance or cleaning operations, be sure that the light in the working area is sufficient and
if necessary, use an additional source of light.
CLEANING THE DISPLAY CASE
1) Every week clean the outer surfaces of the display case with mild soap or detergent in lukewarm water only.
Wipe carefully with a soft cloth. Never clean it using inflammable or scouring agents, alcohol, acetone or solvents.
NEVER CLEAN THE DISPLAY CASE BY THE USE OF WATER JETS. Clean glass surfaces using glass-cleaning
products exclusively. The use of water is not recommended here, as it may cause scale to build up.
20
QUM000149F
Publicité
