ALPATEC ACS 150 ET Mode D'emploi page 15

notice_ACS 150 ET:notice_AC 10 FT
1 RC TRANSMITTER
2 DISPLAY SCREEN
3 MODE
5 ON / OFF
6 NIGHT
7 TIMER
4 TEMPERATURE
8 AUTO FAN SPEED
9 HIGH SPEED
10 MEDIUM SPEED
11 SLOW SPEED
You can run the product either with the
remote control or with the control panel.
Touch 3: select the mode (cooling or
dehumidifying).
Touch 4: each pressure increase or lower the temperature by 1°C
Touch 5: start or stop the product.
Touch 6: night mode. Fan speed will turn to low speed. Temperature will increase by 0,5°C after half an
hour in this mode, then by 2°C after 2 hours.
Press again this touch to cancel the mode.
Touch 7: timer on or timer off.
When the product is ON, it is possible to set an automatic stop. Press the touch 7 till the time on the
screen corresponds to the time you want the product to stop.
When the product is OFF, it is possible to set an automatic start. Press the touch 7 till the time on the
screen corresponds to the time you want the product to start.
Touch 8: automatic fan speed. If auto is selected, the speed will be adapted according to the difference
between ambient temperature and desired temperature. If it is more than 3°C, it turns to high, if it is less
than 3°C, it turns to medium and if it is 0 it turns to slow.
Touch 9: HIGH fan speed.
Touch 10: MEDIUM fan speed.
Touch 11: LOW fan speed.
- Beware of the polarity.
- Do not mix new and old batteries.
- If you don't use the remote control for a long time, please take out batteries.
- At the end of your product's life, remove the
batteries before you hand it for recycling.
- Old batteries have to be hand over a
collection point.
26/02/08 12:03
REMOTE CONTROL
Picto Function
15
Page 15
8
7