Bathing - Invacare Aquatec ORCA Manuel D'utilisation

Masquer les pouces Voir aussi pour Aquatec ORCA:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 49
Aquatec® ORCA / ORCA F / ORCA XL
IMPORTANT!
If the battery in the hand control C is not sufficiently
charged, the red indicator lamp E lights up red when the
Down button D is pressed. In this case, the lowering
function of the bath lift is disabled. You can however
still raise the lift.
– Recharge the battery immediately after raising it.
Raising the bath lift
IMPORTANT!
If the backrest is lowered, it will move into the upright
position first (not on model ORCA F).
1.
Press the Up button B on the hand control and keep it pressed.
The backrest moves into the upright position or the seat moves
upwards.
2.
Release the Up button on the hand control.
The bath lift stops in the current position.
Lowering the bath lift
IMPORTANT!
If the seat is already lowered, the backrest lowers
towards the rear (not on model ORCA F).
1.
Press the Down button D on the hand control and keep it
pressed.
The seat moves downwards or the backrest swivels to the rear.
2.
Release the Down button on the hand control.
The bath lift stops in the current position.
14
Emergency off switch
IMPORTANT!
Only press the Emergency Off button A if the device
does not stop immediately when the Up or Down
button is released (e.g. if a button jams). The bath lift
stops moving immediately and the red light integrated in
the hand control lights up.
If the red indicator light goes out after the emergency off button is
released, the fault has been rectified (e.g. button is released again).
The device is ready to use again.
If the red indicator light stays on after the emergency off button is
released, the fault has not yet been rectified. The device is not ready
for use and must be repaired, e.g. in the event of damage to the
electronics.
Contact your specialist dealer, if necessary.

4.3 Bathing

WARNING!
Risk of slipping
The bath lift can slip if the suction cups do not have
a good hold.
– Before using the bath lift ensure that it is securely
positioned and cannot tip over.
– Ensure that the bath lift is set up in the bathtub, ® 3.3
Setting up the bath lift, page 9 .
1574469-A

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Aquatec orca fAquatec orca xl

Table des Matières