Turning The Appliance Off - Fulgor Milano F7BC24 1 Série Manuel D'installation, Utilisation Et Entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

21 - Turning the appliance off

EN
Below is a list of some of the possible malfunctions.
If the problem cannot be resolved as described, contact Customer Services.
PROBLEM
The coffee is not hot
The coffee is not creamy enough
The coffee is delivered too slowly or a
drop at a time.
The coffee is delivered too quickly
Coffee does not come out of one of
the spouts.
The coffee does not come out of the
spouts, but from around the service
door (A2).
Water comes out of the spouts instead
of coffee.
The milk does not come out of the milk
spout (C5).
The milk is not well frothed.
28
POSSIBLE CAUSE
The cups were not preheated.
The brewing unit has cooled down
because 2/3 minutes have elapsed
since the last coffee was made.
The temperature set is too low.
The coffee is ground too coarsely.
Wrong type of coffee.
The coffee is ground too finely.
The coffee is ground too coarsely.
The spouts are blocked.
The holes in the spouts are clogged
with dry coffee dust.
The coffee guide (A3) inside the service
door is blocked and cannot swing.
The pre-ground coffee may be blocked
in the funnel (A21).
The intake tube is not inserted or is
inserted incorrectly.
The milk container lid is dirty.
The frothed milk regulator is not
positioned correctly.
REMEDY
Warm the cups by rinsing them with
hot water.
Before making coffee, preheat the
brewing unit by selecting the RINSING
function.
Change the set temperature (see
paragraph
"Changing
temperature").
Turn the grinding adjustment knob one
click anticlockwise towards "1" while
the coffee mill is in operation (fig. 14).
Use a type of coffee for espresso
coffee makers.
Turn the grinding adjustment knob one
click clockwise towards "7" while the
coffee mill is in operation (fig. 14).
Continue one click at a time until coffee
delivery is satisfactory.
The effect is only visible after delivering
two coffees.
Turn the grinding adjustment knob one
click anticlockwise towards "1" while
the coffee mill is in operation (fig. 14).
Avoid turning the grinding adjustment
knob
excessively
otherwise
you select 2 cups, the coffee may be
delivered a drop at a time.
The effect is only visible after delivering
two coffees.
Clean the spouts with a toothpick (fig.
27).
If necessary, remove coffee deposits
with a toothpick, sponge or stiff bristled
kitchen brush.
Thoroughly clean the coffee guide
(A3), particularly near the hinges.
Clean the funnel (A27) with a wooden
or plastic fork, clean the inside of the
machine.
Insert the intake tube (C4) in the rubber
washer in the milk container lid (fig.
24).
Clean the milk container lid as
described in the section "Cleaning the
milk container".
Adjust following the instructions in the
section "Making cappuccino".
coffee
when

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

F7bc24b1F7dtk30bcF7bc24s1

Table des Matières