Fulgor Milano F7BC24 1 Série Manuel D'installation, Utilisation Et Entretien page 24

EN
spout
milk intake tube
Hole
3. Remove the frothed milk regulator by pulling it outwards.
4. Wash all the components thoroughly with hot water and
mild washing-up liquid.
Make sure there are no milk residues left inside the
holes and the groove on the fine end of the frothed milk
regulator.
5. Check that the intake tube and spout are not clogged
with milk residues.
6. Replace the frothed milk regulator, milk spout and intake
tube.
7. Replace the milk container lid.
22
Groove
Frothed milk regulator
Hole