NEC MultiSync LCD1850X Manuel Utilisateur page 20

Controls
OSM (On-Screen-Manager) Controls
The OSM controls on the front of the monitor function as follows:
To access OSM press any of the control buttons ( , , -, +).
To change DVI/D-SUB signal input, press the NEXT button.
To rotate OSM between Landscape and Portrait modes, press the
RESET button.
NOTE: OSM menu must be closed in order to change signal input and
to rotate.
Control
EXIT
CONTROL /
ADJUST -/+
NEXT
RESET
NOTE: When RESET is pressed in the main and sub-menu, a warning
window will appear allowing you to cancel the RESET function
by pressing the EXIT button.
01b_English
Menu
Exits the OSM controls.
Exits to the OSM main menu.
Moves the highlighted area left/right to select control
menus.
Moves the highlighted area up/down to select one of the
controls.
Moves the bar left/right to increase or decrease the
adjustment.
Activates Auto Adjust function.
Enter the sub menu.
Moves the highlighted area of main menu right to select
one of the controls.
Resets the highlighted control menu to the factory setting.
Resets the highlighted control to the factory setting.
English-9
9 2/4/01, 3:39 pm