Parrot SEQUOIA Guide Utilisateur page 27

The photos taken by Sequoia are in .tiff format for the four monochrome
sensors, and in .jpeg format for the RGB sensor.
Via USB
1. Using the micro USB cable (supplied), connect the micro USB
device port on the multispectral sensor to your computer.
2. In Windows: go to Start > Computer > Sequoia
> Internal. This will take you to the multispectral sensor internal
memory. You can retrieve the photos taken during the flight.
Note : Sequoia creates a folder for each sequence of shots. For
example, if you have taken a single shot and then a shot in burst
mode, you will have two different folders in the Sequoia memory.
3. For Mac: open Image Transfer. This will take you to the
multispectral sensor internal memory. You can retrieve the photos
taken during the flight.
Via Wi-Fi
1. Connect the multispectral sensor USB device port to a drone or a
USB battery.
> Sequoia turns on automatically.
2. Make sure that the Wi-Fi appears in the list of available Wi-Fi
networks. If not, press the multispectral button four times.
> The multispectral sensor indicator light flashes blue when Wi-Fi
27