Parrot SEQUOIA Guide Utilisateur page 22

the entire test pattern.
6. Press Start.
> A 10-second countdown appears, and the sensor takes three sets
of photos.
Note: once the calibration is complete, a message will tell you
that calibration is complete. Click the link to see the photos
taken during calibration.
Functions of the multispectral sensor button
Use the button to enable/disable burst mode, take photos and enable/
disable Wi-Fi on Sequoia.
Note: Sequoia must be turned on to activate these features.
1 click
2 clicks
4 clicks
Hold down (3 seconds)
Disconnect the multispectral
Press and hold the Sequoia button for 3 seconds to turn it off. The
indicator light goes out. If you disconnect Sequoia while the indicator
22
Take a photo
Enable/disable shots
Enable/disable Wi-Fi
Switch off Sequoia