brennenstuhl professionalLINE BSV 5 3/6 N5160 Mode D'emploi page 13

001820 proLINE Gummi-Baustromverteiler.qxp_001820 BA_proLINE Gummi-Baustromverteiler BSV 5
INTENDED USE
The rubber construction site power distribution box is used as an indoor or outdoor mobile power distributor.
This product is designed for professional use. Any use which is not specified as intended use will be considered
misuse. The manufacturer will not assume any liability for damages resulting from misuse. The user bears the
entire risk.
Unauthorised modifications and conversions will void the CE conformity and with it any warranty claims.
Modifications may cause hazards for life and limb as well as damage to the distribution box or connected loads.
Factory labels on the distribution box must not be removed, changed or made illegible.
PROTECTION AGAINST FOREIGN OBJECTS AND WEATHER
The protection type of this distribution box is IP44 according to DIN EN 60529 (VDE 0470-1) provided that the
correct operating position is observed. See »Commissioning« section. This means:
– Protected against solid foreign objects with a diameter of more than 1.0 mm, e. g. wire.
– Protection against water splashing from any direction.
Not suitable for continuous exposure to water.
GENERAL SAFETY INSTRUCTIONS
Qualified electrician
The qualified electrician must meet and observe the following requirements:
– Intended use of the device.
– Compliance with the installation and operating instructions.
– Knowledge and application of the applicable electrical technical requirements (e.g. DIN VDE 0100 part 600,
DIN VDE 0100 part 410) and the country-specific requirements for setting up electrical technical systems.
– Knowledge and application of the general and specific safety and accident prevention regulations.
– The ability to recognise risks and prevent possible hazards.
– Handover of the installation and operating instructions to the operator/user of the device.
Operation/Use
– Safe use is only ensured if these instructions are fully observed.
– Read these instructions thoroughly prior to installation, commissioning or operation.
– The distribution box must be installed and serviced by qualified experts and put into operation according to
the laws, directives and standards.
– Never cover the distribution box to prevent trapped heat and the resulting fire hazard.
– Keep highly flammable and explosive substances away from the distribution box.
– Protect the cables
• by pulling at the plug and not at the cable to disconnect the device,
• by preventing mechanical damage to the cables,
• by keeping them away from intense heat.
– Protect the housing from mechanical damage such as impacts or powerful blows.
– Never operate the distribution box if it is defective.
– Avoid tripping hazards.
www.professionalline.com
2
13