Adjusting The Sound - JVC KD-AR600 Manuel D'instructions

Adjusting the sound

You can adjust the sound characteristics to your
preference.
1
Select the item you want to adjust.
For KD-AR600:
BAS TRE
(bass) (treble)
VOL
(volume)
For KD-SC500:
BAS
(bass)
VOL
(volume)
Indication
1
BAS* Adjust the bass.
1
TRE* Adjust the treble. –06 (min.)
FAD* 2 Adjust the front
and rear speaker
balance.
BAL Adjust the left
and right speaker
balance.
LOUD* 1 Boost low and
high frequencies
to produce a well-
balanced sound
at low volume
level.
3
SUB.W* Adjust the
(only for subwoofer
KD-AR600) output level.
4
VOL* Adjust the volume. 00 (min.)
24
Each time you press the
button, the adjustable items
change as follows:
FAD BAL
(fader)
(balance)
SUB.W LOUD
(subwoofer) (loudness)
TRE FAD
(treble) (fader)
LOUD BAL
(balance)
(loudness)
To do: Range
–06 (min.)
|
+06 (max.)
|
+06 (max.)
R06 (Rear only)
|
F06 (Front only)
L06 (Left only)
|
R06 (Right only)
LOUD ON
|
LOUD OFF
00 (min.)
|
08 (max.)
|
30 or 50 (max.)*5
* 1
When you adjust the bass, treble, or loudness, the
adjustment you have made is stored for the currently
selected sound mode (C-EQ) including "USER."
* 2 If you are using a two-speaker system, set the fader
level to "00."
* 3
Only for KD-AR600:
This takes effect only when a subwoofer is
connected.
* 4 Normally the control dial work as the volume
control. So you do not have to select "VOL" to
adjust the volume level.
5
* Depending on the amplifier gain control. (See
page 28 for details.)
2
Adjust the setting.
Indication pattern changes as
you adjust the bass or treble.
Ex. 1: When you adjust "TRE" (treble)
Ex. 2: When you turn on the loudness
3
Repeat steps 1 and 2 to adjust the
other items.
To reset each sound mode to the factory
settings, repeat the same procedure and
reassign the preset values listed in the table on
page 23.
To increase the level or
turn on the loudness
To decrease the level or
turn off the loudness