Before Switching The Appliance On; Filter Installation; Proper Placement; Control Instructions - Noaton AE 6160 Mode D'emploi

6 Before switching the appliance on

6.1 Filter installation

1) Disconnect the power cord from the mains.
2) Remove the grill with the pre-filter (4.1, item C) for air intake.
3) Take the evaporation filter out of the plastic bag.
4) Place unpacked filter back to the unit.
5) Then, re-install the grill with the pre-filter for air intake.
6) The average service life of filters under normal use (approx. 8 hours/day) is
approximately 12 months.
Filter type
evaporation

6.2 Proper placement

If the appliance is in operation, make sure that its rear part is situated at least 20
cm from any walls or furniture.
 Install the appliance in an upright position on a stable and level floor.
 Input voltage parameters must comply with the nameplate on the unit, and
the electrical socket must be grounded and properly connected.
 Make sure that the tank is correctly inserted into the unit.
 Turn on the appliance and follow the operating instructions as shown
below.

7 Control instructions

Insert the power cord plug in a properly protected socket. Make sure the input voltage
requirements comply with the values given on the technical nameplate on the appliance.
Code
AE 6160E / HF 3110E
38