Showtime - Carson Street Breaker Mode D'emploi

f. Showtime... almost!
Engine break-in is the most important step to assuring that
your engine is fast and reliable throughout its life. Put simply:
DON'T SKIP THIS PART!
The engine is pre-set from the factory for break-in. Use a "FAT
BONE" 905034 or platform and place the car so that the wheels
are off the ground and free. Make sure the throttle is set at
neutral with your radio. Place the glow heater onto the glow
plug and give the recoil a sharp pull (picture 4). Do not pull it
more than twelve inches! More than that may break the cord
and this is not covered under warranty. It is better to give the
recoil short sharp pulls rather than long ones. If the pull-start
cord gets stuck, rotate the flywheel a little bit with your finger.
This should make the cord automatically recoil. Within a few
pulls, the engine will start with a good puff of smoke.
If the engine has trouble idling at the rich setting, turn the idle
screw clockwise 1/8th of a turn at a time. This will increase
the idle allowing the car to break-in properly. Try to do this in a
Picture 4
well-ventilated area, such as your driveway. Unburned oil from
the fuel will accumulate under the exhaust, so be prepared. Let
the car idle like this for 2-3 tanks of fuel checking the engine
temperature every 2 minutes. Please allow a break of 10 – 15 in
between filling the tank to allow the engine to cool down. You
should be able to touch the head of the engine with your finger-
tips and it will be hot, but not uncomfortably so. If it seems very
hot, richen (turn counter-clockwise) the high-end AND low-end
needles 1/8th of a turn. Always use small increments when
making these kinds of adjustments.
014671_anl_204017_streetbreaker.indd 9 014671_anl_204017_streetbreaker.indd 9
Racer Tip:
Factory setting of carburettor:
With the following basic adjustment the engine starts immedia-
tely, running perfect and rich enough (outside temperature 8°C).
• Idle stop screw: approx. 1 mm air gap;
• High speed needle valve: screw in completely, then open 4
full turns;
• Low speed needle valve (linking): flush with the edge of the
linking arm, then 1 full turn clockwise;
After run-in is finished the high speed needle valve should be
open at least 3 and 1⁄4 turns. A richer setup is better if outside
temperature is high.
Picture 5
rich
Picture 6
rich
low
RPM
high
RPM
Racer Tip:
Drive your car slowly with the rich setting shortly after the
break-in period avoiding prolonged periods at full throttle. Gra-
dually lean out the mixture 1/8 of a turn at a time. The idle will
increase the more you lean the engine out.
CARSON Street Breaker 204017
lower
lower
9
09.08.2010 17:18:04 Uhr 09.08.2010 17:18:04 Uhr
GB