Dometic PERFECTVIEW VT100WiFi Instructions De Montage Et De Service page 13

VT100WiFi
I
NOTE
Only start sealing through-holes when you have completed all installation work on the
camera and have laid the required cable lengths.
Connecting the transmitter electrically (fig. 1, page 3)
7.2
A
NOTICE!
Make sure the polarity is correct.
VT100WiFi requires a few seconds to initiate the digital wireless connection. To keep this start-up
time short, you should connect the transmitter to a DC voltage supply. If there is no continuous
operating voltage available, you can connect the transmitter to the reversing light.
Connecting the transmitter to a continuous operating voltage
➤ Connect the red cable of the transmitter (5) to an active positive cable of the vehicle battery
e.g. terminal 15.
➤ Connect the black cable of the transmitter (6) to the earth terminal on the bodywork.
➤ Connect the green cable of the transmitter (4) depending on the type of camera:
– Camera without motorised protective cover: to an active positive cable of the vehicle
battery (terminal 15, ignition plus)
– Camera with motorised protective cover: to the reversing light.
➤ Connect the camera connector (3) to the camera.
I
NOTE
For Android
Receiving devices with Android
wireless network connection for accessing the internet. The transmitter creates a
wireless network that does not permit access to the internet. Therefore internet
services cannot be used once the transmitter is being supplied with power.
The use of telephony and text messages is also restricted.
EN
©
operating systems only:
©
Connecting the transmitter electrically
operating systems automatically use the active
13