Using The Transmitter And The App - Dometic PERFECTVIEW VT100WiFi Instructions De Montage Et De Service

Using the transmitter and the app

Connecting the transmitter to the reversing light (no continuous voltage)
I
NOTE
• For this type of connection, only the cameras without the motorised protective
cover can be used.
• On some vehicles, the reversing light only works when the ignition is switched on.
In this case, you must switch on the ignition to identify the positive and earth cables.
➤ Connect the red cable of the transmitter (5) to the positive cable of the reversing light.
➤ Connect the black cable of the transmitter (6) to the earth terminal (–) on the reversing light or
to the earth terminal on the bodywork.
➤ Connect the green cable of the transmitter (4) to the positive cable of the reversing light.
➤ Connect the camera connector (3) to the camera.
8 Using the transmitter and the app
8.1 Installing the VT100WiFi app
To be able to use the system, you need to install the manufacturer's free app on your receiving
device before initial use.
You can find the app in Google Play Store
under the name VT100WiFi.
8.2 Starting the transmitter and app
I
NOTE
• Activate the wireless reception of your receiving device.
• Change the name and password of the wireless network after you have connected
your receiving device for the first time.
When connected to a continuous operating voltage
➤ Switch the vehicle ignition on.
✓ 6 – 8 seconds after starting the vehicle, the transmitter is ready for operation.
➤ Connect your receiving device to the wireless network of the transmitter. Use the address and
the password to do this, which can be found on the transmitter housing.
➤ Start the VT100WiFi app on your receiving device.
✓ The receiving device displays the camera image.
✓ After three seconds without further action, the receiving device switches to full-screen mode.
✓ Double-click on the screen to open the control bar.
14
© ©
(Android ) and in the Apple
VT100WiFi
© © ©
App Store (iOS )
EN