Connecting The Transmitter Electrically - Dometic PERFECTVIEW VT100WiFi Instructions De Montage Et De Service

Connecting the transmitter electrically

Attaching the transmitter (fig. 5 1, page 5)
To perform the installation, proceed as follows:
➤ Hold the transmitter at its installation location and mark the four points for the drill holes.
➤ Drill the holes, with a Ø of 4 mm, at each of the markings.
➤ Screw the transmitter on using M5 x 20 mm self-tapping screws.
Fixing the antenna (fig. 5 2, page 5)
To perform the installation, proceed as follows:
➤ Remove the plastic film from the antenna.
➤ Stick the antenna to the selected installation location.
7 Connecting the transmitter electrically
7.1 General notes on laying cables
I
NOTE
• As far as possible, use original ducts for laying the cables, or other suitable options
such as panelling edges, ventilation grilles or dummy plugs.
If no openings are available, you must drill holes for the cables. Check beforehand
that there is sufficient space on the other side for the drill head to emerge.
• Cables and connections that are not properly installed will cause malfunctions or
damage to components. Correct installation of cables and connections ensures
lasting and trouble-free operation of the retrofitted components.
Therefore, please observe the following instructions:
• Wherever possible, lay cables inside the vehicle, as they are better protected there than
outside.
If you do need to lay a cable outside the vehicle, ensure that it is well fastened (use additional
cable ties, insulating tape etc.).
• To prevent damage to the cables when laying them, ensure that they are far enough away from
hot or moving vehicle components (exhaust pipes, drive shafts, light systems, fans, heaters,
etc.).
• Screw on the plug connections for the connecting cables to protect them against water
penetration (fig. 6, page 5).
• When laying the cables, make sure:
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp-edged ducts without protection (fig. 7, page 5).
• Protect every through-hole made in the bodywork against water penetration, e.g. by using a
cable with a sealant and by spraying the cable and the cable sleeve with sealant.
12
VT100WiFi
EN