Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2
2-1
2
3
3-1
2-4
2-3
2-2
2-3
Fastening the grinding wheel
f Clean the backing flange [2-1] and clamping nut
[2-3], as well as grinding wheel fastening areas
[2-2].
f Mount grinding wheel [2-2]. Flange fitting must
fit the grinding wheel aperture.
f Press in the spindle blocking plunger [1-6].
Press in the blocking plunger only when device
2-5
is switched off and spindle not active.
f Turn the spindle until blocking plunger fits in.
f Adjust the two wings of the clamping nut [2-3]
to match the two grooves of the spindle.
f Screw the clamping nut [2-3] by fitting it from
the grinding wheel [2-2] on the spindle [2-5].
f Fasten the clamping nut [2-3] with key [2-4].
f Before starting the device, make sure the grind-
ing wheel rotates smoothly.
L
Use only grinding wheels recommended by
the manufacturer and designed flange, which are
included in the package.
Positioning the handle
Sufficiently release the handle manual screw [1-9]
and tilt the handle [1-5] to set the most suitable
working position. Re-fasten the manual screw [1-9].
Always work with connected suction device. Insert
the suction device pipe into the suction extension
– see figure [5]. In order to increase the efficiency,
we recommend to use pipes with
L
Use solely suction devices with antistatic
pipe design.
Lifting the front brush
For wall lifting, it is possible to lift the lifting seg-
ment [3-1] – see figure [3].
14
Operation
Dust suction
36 mm ( 1,4 ").
Publicité
Chapitres
Table des Matières
