Technical Data; Symbols; Intended Use; Functional Description - Festool RENOFIX RG 130 E Guide D'utilisation

To reduce your exposure to these chemi-
cals work in a well ventilated area and
use approved safety equipment, such as
dust masks that are specially designed
to filter out microscopic particles. Wash
hands after handling.
O REDUCE THE RISK OF IN-
T
JURY, USER MUST READ INSTRUCTION MANUAL.

Technical data

Nominal voltage
Power consumption
Mains frequency
Power input
Adjustable rpm
Tool
Connecting thread of the drive shaft
Backing flange
Weight
Protection class

Symbols

Warning of general danger
Risk of electric shock
Read the Operating Instructions/Notes!
Wear ear protection
Wear protective goggles
Wear a dust mask
Use protective gloves!
Disconnect from power supply
Both hands required
Double insulation
Do not dispose of as domestic waste.
120 V ~
13 A
60 Hz
1600 W
5000 – 7700 min (rpm)
–1
130 mm (5,1")
M14
25mm (0,99'')
3.8 kg (8,4 lb)
II /
Advice or tip
L
V Volts
A Amperes
Hz Hertz
W Watt
~ Alternating current
n No load speed
0
Class II Construction
min Revolutions per minute
-1
(rpm)
" inch
lb pound
Ø Diameter
mm millimeter
kg kilogramm
°C Celsium
°F Fahrenheit

Intended use

The machine can only be used for dry grinding using
an efficient suction device.
The machine is constructed for use with special
wheels recommended by the manufacturer and
they must not be used with a wheel made from
connected ABRASIV material.
The device is designed to remove paint and glue
from wooden and concrete surfaces.
Further it is also an initial use to flatten and smooth-
en wooden and concrete surfaces.
Noncompliant use of the machine is a sole respon-
sibility of the user.

Functional Description

The pictures for the functional description are on
a fold-out page at the beginning of the instruction
manual. While reading the manual you can fold out
the page for comparison and quick reference.
[1-1] Switch
[1-2]
Arresting lever
[1-3] Suction extension
[1-4]
Revolutions regulation wheel
[1-5] Front handle
[1-6]
Spindle arresting button
[1-7] Brush tilting segment
[1-8]
Brush
[1-9] Handle manual screw
[2-1] Backing flange
10