Proper Use; Transport/Winterizing - STA-RITE Boost-Rite S4P100M Mode D'emploi

Masquer les pouces Voir aussi pour Boost-Rite S4P100M:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 11
2.3.2
Other
Safety
Regulations
Work on electrical components must be carried
out by a qualified electrician in accordance with
accepted technical practices.
The operating instructions provided by the motor
manufacturer (if applicable) must be followed at
all times.
The electrical equipment of the pump must be
inspected and checked regularly. Faults such as
loose connections or damaged cables must be
corrected immediately.

3. Proper Use

The product is designed for the pumping of clear
or slightly cloudy water in swimming pool
applications.
In
case
applications, the exact usage specification must
be discussed with the manufacturer.
The product must only be used as specified in
these instructions. Any other form of use
constitutes improper use. In this case, the
manufacturer accepts no liability for any resulting
damages.
The product has been designed and constructed
to the latest state of technology, and is
completely
safe
and
accordance with these operating instructions and
any
other
specific
requirements.
Nevertheless, their use may still give rise to
danger to life and limb of the operator or other
persons, or damage to the product or other
equipment.
Modifications to the product is possible in certain
cases. In such cases, advance, written approval
must be obtained from the manufacturer.
The manufacturer accepts no responsibility in
the following cases:
Failure to observe the information in these
operating instructions
Use of spare parts or components not
approved by the manufacturer
Incorrect operation
Removal, modification or deactivation of safety
devices
Improper performance of maintenance work
Improper use
Components
and
of
other
media
or
reliable
if
used
in
system
or
operating
3.1 Improper Use
The product may cause dangers if used
improperly or not for their intended purpose.
Under no circumstances must the pump be
used for aggressive fluids, inflammable fluids,
toxic fluids or other unapproved solutions.
Do not use the pump if people are in the
swimming pool.

4. Transport/Winterizing

The complete delivery should be checked
immediately on arrival for completeness and any
possible transport damage. Complaints will only
be accepted if they are reported to the shipper or
manufacturer on the day of delivery.
4.1 Unpacking
The packaging materials should be reused if
possible, or disposed of in accordance with local
regulations.
4.2 Storage – Winterizing
Extended intermediate storage in an
environment with high air humidity
and changing temperatures should
be
avoided.
damage the motor windings and
Attention
other
metallic
invalidate the guarantee.
The pump may also be damaged if
exposed to frost. This will also
invalidate the guarantee. Anti-freeze
must not be used, since this can
Attention
cause damage to plastic parts.
In the event of risk of frost, the pump should be
drained thoroughly. To do this, open the drain
plug and allow water to drain out of the pump.
Also tip the pump upside down to drain any
additional water from discharge port of the pump.
The piping system should also be emptied
completely of water.
Check all water pipe connections when re-
installing the pump after the winter or extended
storage periods. Open the shut-off valves in the
suction and pressure lines. Close all drain valves
in the system and on the pump. Start the pump in
accordance with the instructions given in the
Installation section of this manual.
4
Condensation
may
parts.
This
will

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Boost-rite s5p150m

Table des Matières