Installation of camera in the trailer
1. Secure that there is not power in the trailer
2. Choose the right place of the camera to monitor your animal and keep it in distance to the animal
3. Choose the power source of the trailer (mainly light power source) and connect the camera power cable with bare
black/red end to the right cable in the power source. Important: If you are unsecure about the right connection call
a professional for helping you!
4. Connect the trailer with the car in order to get power supply.
5. Check with your LCD (charged before completely) if there is a clear picture.
6. Ask a second person to help in adjusting the correct position of the camera and mark the fixing points.
7. Fix the extra mounting foot and adjust the camera finally.
8. Fix the car-holder of the LCD monitor and press the channel selector in order to receive the picture.
Troubleshooting
Device
LCD Monitor
Camera connected
with pin-antenna
Camera connected with
antenna
Problem
Is not working
Power but no picture
Is not working
Power but no picture on
the LCD Monitor
No clear picture
No picture or black/white picture
No clear picture
Solution
Load/replace battery
Switch on the power button
Check the plug used for charging
(must be 5 volts output)
Choose the right channel
Check camera
Check the plug used for power
(must be 12 volts output)
Choose the right channel on LCD
Check antenna connection
Reduce distance between camera/LCD
Change camera sending channel
Change camera channel or realize interference
source (i. e. WLAN) and change frequency
AVLink sends on ch1 – check if ch1 is on the LCD
Check cable and connection of antenna cable/
AVLink cable and power connection of AVLink
Remove obstacles between the antennas (if
possible) or replace antenna
Change camera/AVLink channel or realize interfe-
rence source (i. e. WLAN) and change frequency
Check connections at AVLink (antenna cable,
power supply)
32