Kerbl 1085 Guide D'utilisation page 28

Caméras pour l'étable et la remorque 2,4 ghz
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 13
How the StableCam works
1. The camera films the animal and transmits the audio/video signal via the antenna-cable to the antenna.
2. The external antenna (sending part) transmits the signal wireless (2.4 GHz) over a distance of 1200 m to the opposite
antenna (receiving part).
3. Via the antenna-cabel the signal will be transfered tot he Audio/Video-Link (AVLink)
4. The AVLink transmits wireless the signal to the LCD-Monitor (up to a distance of 100 m without wall etc. – every
obstacle reduces the distance by 50 %). Metal or concrete obstacles will reduce the signal strength significantly.
5. It can be used up to 2 cameras with 1 AVLink
Best picture quality is obtained if there is no block objects between the transmitting and the receiving antenna (10dBi).
Two antennas pointing at each other give you a wireless range of 1200 meters with a clear line of sight.
It is important to place both antennas outside of the walls to reduce the number of obstacles. No obstacle like trees,
walls etc must be inbetween the 2 antennas and they must be pointed exactly to each other – otherwise no signal will
be received.. The included antenna cable allows the camera to be placed up to 25 m from the transmitting antenna
(10dBi).
Camera: Setup in the barn
The included antenna cable will allow you to set up the camera
25 meters away from the transmitting antenna (10dBi) and 10
meters away from wall socket.
Choose the right place for your camera in order to monitor the
area properly. You can test easily the covered area: fix the small
antenna on the camera and connect it with the 230/12 volts
charger. Choose the right channel on the LCD monitor by pres-
sing the channel button and check the picture.
First of all check if the battery is inserted
correctly in the LCD monitor and charge it
until the red light disappears at the monitor
channel switching button (after approx.
2 hours).A fully charged battery will run
for approx. 2 h
You need the charged monitor for testing of
the camera!
28
12V

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

10861087Stablecam 1085Stablecam 1086

Table des Matières