Kerbl 1085 Guide D'utilisation page 27

Example of how to use the looping mode
If you have two cameras that transmit on channel 3 and 4, then set looping interval 5 seconds.This way the AVLink will receive pictures from the
cameras on channel 3 and 4 alternately (with an interval of 5 sec.) and transmit the pictures to the LCD-monitor on channel 1 or 2. You will
automatically get supervision of two cameras without manually changing the channel. LED indicators on AVLink will display which channel is
receiving and which channel is resending. This allows images from maximum of 3 cameras to be received and transmitted simultaneously with
AVLink. However, the processing possibility depends on local conditions and possible sources of interference.
A/V connection with your TV
The AVLink is not only a range extender but you can connect it directly with your TV with the included AV-cable (yellow/red).
For further instruction see your TV manual. The receipt on TV does not influence the video signal to the wireless LCD monitor.
The following antennas are included in your StableCam™-solution
and should be used in the following places:
1. Black camera antenna (2dBi).
The black camera antenna should be attached to the camera when adjusting the camera angle during
installation in the stable. Before you start your installation, start by attaching this antenna at the back of
the camera. It is transmitting in a 360° angle.
Due to unexpected fluctuations of transmission power when the camera is operated with the small rod
antenna, we strongly recommend to use the camera only with the original black video cable connected
with the external yagi antenna. To use the camera with the rod antenna could lead to an infringement of
the telecommunication law and must be excluded from our liability.
2. Transmitting 1072-antenna (10dBi).
The transmitting antenna (10dBi) is connected to the camera with the included 25 meter antenna cable.
It transmits signal with full strength in the direction the antenna is pointed to!
3. Receiving 1072-antenna (10dBi).
The receiving antenna (10dBi) is connected to the receiving part of the AVLink inside your house with the
included 5 meter antenna cable.
4. Transmitting black flat AVLink antenna (5dBi).
The transmitting AVLink antenna is connected to the transmitting part of the AVLink. This antenna makes
sure that you get better picture quality inside your house.
ü
CABLES
Antenna cable (25 m) for mounting between camera
and transmitting 1072-antenna (Art. nr 1073)
Antenna cable (5 m) for mounting between AVLink
and receiving 1072-antenna (Art. nr 322034)
27