BabyGo Universal Mode D'emploi page 22

4.3 Wright usage of buckle
Step 1
To use the buckle accurately, please proceed as follows:
Step 1: Put the two metal sections of the buckle connector together.
Step 2: Slot the two buckle connectors into the slot in the buckle until they
„click" place.
Step 3: Check the harness is correctly locked by pulling the shoulder straps
upwards.
To release the connectors, you can press the red button of the buckle down-
wards, the two metal sections will be pop up.
4.4 Adjust and use the harness
Loosen the harness
The harness is slackened by
pressing the adjuster (under
the seat cover) on the front
of the seat.
Press down the adjuster as
you grip the two shoulder
straps with your another
hand. Pull the shoulder
straps towards you to loosen
the harness.
22
Step 2
Tighten the harness
Pull the shoulder straps upwards to remove
the slack from the lap sections of the harness
then pull the adjuster strap until the harness
is fully tightened.
The harness should be adjusted as tightly
as possible without being uncomfortable to
your child.
A loose harness can be dangerous.
Check the harness adjuster and tighten each
time the child is placed in the seat.
Car Seat + Isofix
Step 3