Metabo PowerMaxx BS Notice Originale page 8

en ENGLISH
Original instructions
1. Declaration of Conformity
We declare under our sole responsibility: These
cordless drill / screwdriver, identified by type and
serial number *1), comply with all relevant
requirements of the directives *2) and standards
*3). Technical file at *4) - see page 3.
2. Specified Use
The cordless drill/driver is suitable for screwing,
drilling and thread cutting.
The user bears sole responsibility for any damage
caused by improper use.
Generally accepted accident prevention
regulations and the enclosed safety information
must be observed.
3. General Safety Instructions
For your own protection and for the
protection of your electrical tool, pay
attention to all parts of the text that are
marked with this symbol!
WARNING – Reading the operating instruc-
tions will reduce the risk of injury.
WARNING Read all safety warnings and
instructions. Failure to follow all safety warn-
ings and instructions may result in electric shock,
fire and/or serious injury.
Keep all safety instructions and information for
future reference.
Pass on your electrical tool only together with these
documents.
4. Special Safety Instructions
Hold tool by insulated gripping surfaces, when
performing an operation where the cutting
accessory may contact hidden wiring. Cutting
accessory contacting a "live" wire may make
exposed metal parts of the electrical tool "live" and
could give the operator an electric shock.
Ensure that the spot where you wish to work is free
of power cables, gas lines or water pipes (e.g.
using a metal detector).
Slightly acidic, flammable fluid may leak from
defective Li-ion battery packs!
If battery fluid leaks out and comes into contact with
your skin, rinse immediately with plenty of water. If
battery fluid leaks out and comes into contact with
your eyes, wash them with clean water and seek
medical attention immediately.
Protect battery packs from water and
moisture!
Do not use faulty or deformed battery packs!
8
Do not expose battery packs to naked flame!
Do not open battery packs!
Do not touch or short-circuit battery packs!
Remove the battery pack from the machine before
any adjustment or maintenance is carried out.
Before fitting the battery pack, make sure that the
machine is switched off.
Keep hands away from the rotating tool!
Remove chips and similar material only with the
machine at standstill.
Dust from material such as paint containing lead,
some wood species, minerals and metal may be
harmful. Contact with or inhalation of the dust may
cause allergic reactions and/or respiratory diseases
to the operator or bystanders.
Certain kinds of dust are classified as carcinogenic
such as oak and beech dust especially in
conjunction with additives for wood conditioning
(chromate, wood preservative). Material containing
asbestos must only be treated by specialists.
- Where the use of a dust extraction device is
possible it shall be used.
- The work place must be well ventilated.
- The use of a dust mask of filter class P2 is
recommended.
Follow national requirements for the materials you
want to work with.
LED lights (2): Do not observe the LED radiation
directly with optical instruments.
5. Overview
See page 2.
1 Chuck *
2 LED lights
3 Adjusting sleeve (torque control, maximum
torque)
4 Slide-switch (1st/2nd gear)
5 Battery indicator to check the battery's charge
level
6 Belt hook
7 Rotation selector switch (direction of rotation
setting, transporting safety device)
8 Trigger
9 Battery pack release button
10 Battery pack
11 Protective cap *
* depending on model
6. Use
6.1 The machine's multifunctional monitoring
system
If the machine switches off automatically, the
machine electronics have activated automatic