Q UI C KIE PU LS E
40
Mating Connectors
To connect the communication cables: Holding the connector housing, firmly push the con-
nector into its mate until you can no longer see the yellow plastic. The connectors are
secured using a friction system.
To disconnect the communication cables: Holding the connector housing firmly, pull the
connectors apart.
NOTE–
Do not hold or pull on the cable. Always grip the connector when connecting and discon-
necting.
When the control system is first switched on after a connection, or system component
change, the timer will be displayed while the system checks itself. Then the re-start icon will
be displayed. Switch the control system off and on again to operate,
T. JOYSTICK RETRACTABLE MOUNT
The joystick or Enhanced Display is mounted with a mechanism which allows the control to
be locked in a forward or retracted position using magnets.
Adjustment
a. To retract the joystick, push outward on the inside of joystick.
b. Push the joystick away from front of armrest until it locks into retracted position.
c. To return to forward position, push the joystick forward until it locks into place.
U. SHROUD REMOVAL
The plastic protective shroud can be removed for adjustment or servicing.
1. Remove the top shroud
a. Remove the Seat (Section Q previous page).
b. Remove the six screws(A) that hold the shroud to the frame.
c. Once all of the screws have been removed, the shroud should be free to remove.
2. Remove the rear shroud
a. Remove the two rear shroud screws.
b. Pull downward at the top of the rear shroud, then lift up and off.
3. Replacing the front, or rear shroud
a. Position the shroud and hand thread a few screws to hold the shroud in place.
b. You can then insert the other screws while moving the shroud to line up the holes.
c. Be sure not to tighten screws too much, because it could fracture the plastic.
V. CONTROLLER POSITION
You can move the controller in or out in relation to the armrest. You can also move the
controller to either side of your chair to accomodate either left-hand or right-hand use.
Be careful of pinching your controller cords. When the controller is moved, the harness
and cord can be at risk of pinching from the Seat frame, and/or the Power base frame. Be
sure to route and secure the cord with a zip tie to avoid cord pinching,. Cord pinching
could eventually disable your power chair if left unchecked.
1. Extending the controller
a. Flip up the armrest so that it is perpendicular to the floor.
b. Loosen the thumbscrew (B) on the controller bracket.
c. Slide the controller in or out of the armrest to the desired position.
d. Tighten the thumbscrews (B) to secure the controller.
(Optional)
42
43
44
WARNING
VIII. SET-UP, ADJUSTMENT, AND USE
41
23
40
41
42
A
43
44
B
119832 Rev. D