Quickie Pulse 6BC Mode D'emploi page 20

Q UI C KIE PU LS E
3. Seat depth adjustments with 1" increments
a. Using a 5mm Hex Key, remove the M8 Flat head screws(A), (3 on each side)
b. Using a 5mm Hex Key, remove the M8 Flat head screws (B), (1 on each side)
c. Using a 5mm Hex Key, loosen the M8 Flat head screws (C), (1 on each side)
d. While holding the backrest on each side, slide it front or back to achieve the desired
position.
NOTE– Changing the seat depth can effect the balance of your chair. Test the chair carefully
before regular use if a seat depth adjustment has been made.
4. Seat depth mounting positions
a. Using the Seat depth mounting positions table, and the hole number callouts, reference
the correct hole positions to achiever the desired width and depth.
5. Back height adjustments with 1" increments
NOTE– There are 3 positions of adjustment in 1" increments for the back. Position 2 (+2)
(D), Position 1 (+1) (E), and position 0 (default) (F).
a. Using a 5mm Hex key, remove the M8 flat head screws (3) on each side.
b. Position the backrest at the desired height. The top screw should be mounted as
shown (figure 26).
c. Holding the backrest in place, tighten the screws.
d. Repeat the steps on the other side, and ensure that the left and right sides are posi-
tioned at the same height.
6. Armrest width adjustment
NOTE– You can change the armrest widths independantly, remember that this adjustment
will increase the overall width of the wheelchair.
a. Locate the 2 armrest fasteners (G) on each side of the armrest receiver bracket.
b. Loosen the fasteners.
c. Slide the armrests in or out to the desired width.
d. Re-tighten the fasteners.
7. Armrest height adjustment
a. Using a 4mm Hex key, loosen the two M5 set screws(H) located on the armrest
receiver.
b. Raise or lower the armrest to the desired height.
c. Tighten the set screws to secure the armrest.
119832Rev. D
24 25
26
27
28
VIII. SET-UP, ADJUSTMENT, AND USE
5
6
7
8
9
20
1
2
3
5
4
6
7
8
9
D
E
F
G
H
24
25
1
2
3
4
26
27
28