Seat To Floor Height/Pre-Tilt Positioning; Q.seat Pan And Back Size Adjustments; Joystick; Power Recline, Tilt And Lift Operation - Quickie Pulse 6BC Mode D'emploi

Q UI C KIE PU LS E
P. SEAT TO FLOOR HEIGHT/PRE-TILT POSITIONING
Your ASAP II seating system can be adjusted to many different seat to floor heights, and pre-
tilt positioning depending on your specific configuration. Seat to floor heights and Pre-tilt
positioning should only be altered by a trained medical professional. For the correct Pre-tilt
settings and seat to floor heights, in relation to specific configurations of the Pulse, please
Refer to the seat to floor matrix in the Pulse service manual before changing any of the fac-
tory settings.
DO NOT increase the front post height independent from the rear posts when providing
seating pre-tilt.
NOTE– For chairs configured with SPOT tilt, do not increase the Pre-tilt greater than 3 degrees.
For chairs configured with seat elevator, do not increase the Pre-tilt greater than 3 degrees.
For chairs configured with SPOT tilt and seat elevator, do not increase the seat-to-floor
height greater than 1" fron the lowest position.
For chairs configured with SPOT tilt and recline, do not increase the seat to floor height
greater than 18", and do not increase the pre-tilt greater than 0 degrees.
Q. SEAT PAN AND BACK SIZE ADJUSTMENTS
Your ASAP II seating system can be adjusted to a wide range of widths and depths to accom-
modate specific user needs. Seating dimensions should only be altered by a trained medical
professional and may require new seat cushions. Please refer to the Pulse Service Manual
for more detailed instructions on how to customize the size of your seat.
R. JOYSTICK
37 38
Controls:
Two types of joysticks are available: LED and Color Display.
The joystick assembly has 3 components: The Joystick, The Power Module, and the
communications cable.
39
Omni Input/Display
The Omni is a universal specialty controls interface that accepts signals from many different
types of SIDs and translates them into commands compatible with the PG Drives Technology
RNET control system.
S. POWER RECLINE, TILT & LIFT OPERATION
The power recline, tilt and lift features on your chair can all be operated using the joystick on
your chair. Follow the instructions below to operate:
1. Make sure your controller is on.
2. From the Drive Mode, press the Mode button to enter Power Seating Mode.
3. Move the joystick left or right selecting the power option (recline, tilt, lift, legrests) you
wish to control.
4. Move the joystick forward or backward to adjust the selected power option to the
desired position.
5. Press the Mode button to return to normal operation or continue moving the joystick
left or right to adjust the next power option. Multiple Mode button presses will be
necessary if other modules, such as Bluetooth or Output, are active.
119832Rev. D
WARNING
39
VIII. SET-UP, ADJUSTMENT, AND USE
35 36
Rear Seat post
LCD
screen
Profile
22
Front Seat post
Hole 1
Hole 2
Hole 3
Hole 4
Hole 5
Hole A
Hole B
Hole C
Hole D
Hole E
Joysticks
LED Color
oystick
J
Power
module
communication
cable
Omni Display
Mode
Navigation
On/Off
35
36
37
38
39
+/-