Quickie Pulse 6BC Mode D'emploi page 14

Q UI C KIE PU LS E
SECUREMENT POINTS
Rear securement points(A), front securement points(B), Pelvic Belt
Securement point(C)
SECURING THE WHEELCHAIR
This wheelchair is to be used only with Wheelchair Tie-down and
Occupant Restraint Systems (WTORS) that have been installed in
accordance with the manufacturer's instructions and SAE J2249.
NOTE–A copy of SAE J2249 Wheelchair Tie-down and Occupant
Restraint Systems (WTORS) for use in Motor Vehicles can
be obtained from:
SAE International
400 Commonwealth Drive.
Warrendale, PA. 15096-0001
(877) 606-7232 or (724) 776-4970
Attach WTORS to the tie-down brackets in accordance with the
manufacturer's instructions and SAE j2249.
SECURING THE OCCUPANT:
WHEELCHAIR-ANCHORED BELTS
WARNING
Only use a pelvic belt system that meets the requirements of
ANSI-Resna WC Vol 1 Section 19 and SAE J2249, and has been
specified to work in conjunction with the Quickie Pulse 6 transit
system.
1. Installation
a. Install the pelvic belt (D) onto the pelvic belt securement
point anchored to the seating frame of the Quickie Pulse 5
or 6. Using a 10mm Hex key, torque the screw to 144in-lbs
securing the pelvic belt to the mounting anchor (C).
b. Repeat step 1 for the opposite side.
c. Upper torso attachment point(E) shown.
VEHICLE-ANCHORED BELTS
This wheelchair has an overall rating of "A" with regard to accom-
modating the use and fit of vehicle-anchored belts. This rating is
scored as follows: A = Excellent, B = Good, C = Fair, D= poor.
The test for Lateral Stability Displacement for Point (P) is shown in
the figure at right. The average test result for point (P) is:
• Quickie Pulse 6 - 0.547inches (13.9mm)
• Quickie Pulse 5 - 0.547inches (13.9mm)
NOTE–Figure 5 shows the rear view of the wheelchair and human
surrogate secured on test platform and tilted to 45°.
119832Rev. D
3
4
4
5
14
VII. WARNINGS: COMPONENTS AND OPTIONS
A
C
3
B
C
4
D
E
5