What To Do If - IKEA ISANDE Mode D'emploi

Masquer les pouces Voir aussi pour ISANDE:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ENGLISH
What to do if ...
What to do if...
The control panel is switched
off, the appliance does not
work.
The inside light does not work.
The temperature inside the
compartments is not low
enough.
There is water on the bottom of
the refrigerator compartment.
Possible causes:
The appliance could be
in On/Standby mode.
There may be an
appliance power supply
problem.
The light may need
replacing.
The appliance could be
in On/Standby mode.
There could be various
causes (see "Solutions").
The defrost water drain
is blocked.
Solutions:
Activate the appliance with
the On/Standby button.
Make sure:
- there is not a power outage
- the plug is properly inserted
in the power socket and the
mains double-pole switch
(if present) is in the correct
position (i.e. allows the
appliance to be powered)
- the household electrical
system protection devices are
efficient
- the power cable is not
broken.
Models with lamp: disconnect
the appliance from the power
supply, check the lamp and,
if necessary, replace it with
a new one (see the section
"Changing LED"). Models with
LED lights: contact the After
Sales Service.
Activate the appliance with
the On/Standby button.
Make sure:
- the doors close properly
- the appliance is not installed
near a heat source
- the set temperature is
adequate
- the circulation of air through
the vents at the bottom of the
appliance is not obstructed.
Clean the defrost water
drain hole (see the section
"Appliance Maintenance and
Cleaning").
10

Publicité

Table des Matières
loading

Table des Matières