Publicité
Les langues disponibles
Les langues disponibles
4. OPERATION
A.
STAND ALONE OPERATION : Sound activation and AUTO
This mode allows a single device to react to the sound of music.
Place the device in a suitable and stable position.
-
Set the dipswitch to select AUTO or Sound active mode.
-
Turn on the unit. The unit resets then it begins to work.
-
The unit will react to low frequencies through the internal microphone. Adjust the sound
-
sensitivity with the appropriate knob located at the rear of the unit. The LED indicates
whether the music mode is activated.
B.
MASTER / SLAVE MODE
This mode allows you to connect up to 32 units together without controller.
Install the unit in a suitable and stable position.
-
Choose a unit to function as master mode, set dipswitch to select AUTO or Sound active
-
mode. The others must be set in slave mode. Set the DIP switch to slave mode.
Use an XLR cable to connect devices together. Taken at the rear of the unit.
-
Turn on all units. The devices reset and then begin to work. The slave units will react the
-
same as the master unit.
The units respond to low frequencies through the internal microphone. Adjust the sound
-
sensitivity with the appropriate knob located at the rear of the unit. The LED indicates
whether the music mode is activated.
Publicité
