Publicité
Les langues disponibles
Les langues disponibles
C.
UNIVERSAL DMX MODE
This mode allows you to use the DMX 512 console to operate your devices.
Install the unit in a suitable and stable position.
-
Use an XLR cable to connect devices together. Taken at the rear of the unit
-
Assign a DMX address for each device using the DIP switch. Please refer to the chart
-
on the last page.
Turn on all devices. The units reset, then begin to start working.
-
Use a DMX console to control your devices.
-
NOTE:
DMX console can not be operated in Master / Slave (AUTO / SOUND ACTIVE mode)
There must be only 1 single master unit in Master / Slave mode
5.TROUBLESHOOTING
1.
If the power indicator does not lit up and the device does not work, please check the power
cable is properly connected and if the input voltage is compatible with that of the device.
2.
In Stand alone operation, if the power indicator lights up and sound active indicator does not
lit up and the light beam does not work.
The sound is too low. Increase the volume of music or sound sensitivity.
-
Check if the device is in slave mode then set up in master mode.
-
3.
In Master / Slave mode, the slave units does not work
Make sure there is only 1 single unit in the master channel and the other units are set as
-
a slave.
Make sure you are not using a DMX console
-
Make sure the cables are of good quality and the connections are properly made.
-
4.
In DMX mode, the beam does not work and the DMX signal is off.
Make sure the DMX mode is activated.
-
Make sure the cables are of good quality and the connections are properly made.
-
5.
In DMX mode, the laser is not controlled by the DMX console, DMX signal indicator flashes.
Make sure the console and the units have the same channel.
6.
If the direction of the beam is not correct, restart the machine.
7.
If the unit does not work properly, turn the unit off then back on.
If the unit meets other operational problems, we recommend that you contact your dealer.
Publicité
