Publicité
Les langues disponibles
Les langues disponibles
OPERATION
H
E
F
I
L
D
J
A Switching on/off
You can switch the unit on or off by pressing button A. This button is also used to reset the cleaning
indicator light (by holding down).
B Hygrostat (pre-set moisture level)
By pressing button B you can set the desired moisture level in %. A relative moisture of between 40 and
60% is recommended. The accuracy of measurement is +/- 5%. The unit will switch off when the moisture
level exceeds the desired setting. During selection the target value is displayed (symbol DESIRED). The
display will automatically show the current humidity value after a few seconds (symbol CURRENT).
C Timer
Using button C, the operation time can be set – adjustable between 1 and 8 hours, or continuous
operation (CO). Symbol G shows the operating period that has been set (1h/2h/3h/4h/5h/6h/7h/8h/CO).
The display will automatically show the current value after a few seconds.
D Controlling mist output and Evaporator output
By repeatedly pressing button D you can control the mist output. Symbol H shows which of the three
levels (low/medium/high) you have selected.
E Operation with pre-heating
Button E is used for switching the pre-heating on and off (symbol I lights up). As a result, the water
is pre-heated to a temperature of 80° C before entering the nebuliser space. It takes approx. 10 to 15
minutes for the water in the base to warm up. The mist now leaves the nebuliser space at a pleasant
temperature of 40° C. The advantage of this is that the room temperature does not drop and, in additi-
on, it significantly improves the water quality maintenance.
42
Solis_Digisonic_Betriebsanleitung.indd 42-43
A
C
G
M
B
K
F Auto/Sleep Mode
The automatic and sleep modes can be activated by pressing button F. By pressing the button once, the
automatic function is switched on (symbol J appears on the display), maintaining the optimum humidity
subject to the temperature. Control takes place by means of output quantity and pre-set target value. If
the sleep function is switched on (the symbol K appears on the display), the target humidity is 50-65%;
the operation time is automatically set at 6 hours; the heating is switched on. In addition, the output
quantity is also controlled subject to the difference between the target value and the actual value.
The hygrostat and mist output settings cannot be changed in either mode. If the buttons B or D are
pressed, the unit will no longer be in auto or sleep mode.
G Timer Indicator
H Mist Output Indicator
I Pre-heating Indicator
J Auto Mode Indicator
K Sleep Mode Indicator
L Empty indicator
The transparent water tank makes it possible to see the water level well. Furthermore, the unit shows on
the display (L) when water must be added. Please read the chapter «Filling the tank» for more information.
The symbol L may stay illuminated for some seconds with a refilled tank until the base is filled with water.
M Cleaning indicator
If symbol M and «CLEAN» appear on the display, the appliance should be cleaned as recommended by
the manufacturer. This symbol comes on automatically every 2 weeks, depending on the level of use.
The display can be cancelled by depressing button A for between 10 and 15 seconds.
43
27.05.10 09:58
Publicité
