Servicing - Jotul C 24 Manuel D'installation

6.0 Service
Warning! Any unauthorised changes to the product are illegal!
Only original spare parts may be used!
6.1 Replacing the burn plates
Fig. 28
A
Fig. 29
A Ø10mm
1. Remove the side burn plates by lifting them slightly and
pulling out at the bottom (Fig 3).
2. Remove the screws (Fig 28A) and pull the back burn plate out.
Hold simutaneously the baffle (Fig 28B) up so it does not fall
down. Please note that the seal on the back burn plate needs
to be replaced if damaged .
3. To install the burn plates, follow the same procedure in
reverse order
6.2 Replacing the baffle/exhaust
deflector
1. First remove the side burn plates (Fig.3). It is not necessary to
remove the back burn plate .
2. Pull the baffle (Fig. 28B) forward and down at the front edge.
Turn it so that it is standing diagonally behind the front, and
lift it out.
3. Lift the back edge of the exhaust deflector (Fig. 30A), push it
backwards and then down at the front edge.
B A
B
4. To install them, follow the same procedure in reverse
Fig. 30
english
A
order.
19