Actuating The Door Opener; Changing The Bell Tone - Renkforce 1373174 Notice D'emploi

• You can change the following settings with the blue LED (9) kit:
- " " (3) or " " (6) buttons: Changing the playback volume
- " " (4) or " " (7) buttons: Changing the display brightness
• If you want to take a photograph of the user, briefly push the "
• To activate the door opener, briefly push the "
nected to the potential-free switching contact of the outdoor unit is activated for
approx. one second (cannot be changed).
• To terminate the talk (or monitoring of the camera image), briefly push the "
(12). The display goes out; the indoor unit is now back in standby mode.
If the microphone is still active, it is activated when the "
the first time. Push the "
unit to switch to standby mode.
g) Actuating the Door Opener
Activation of the door opener is only possible if a camera image is displayed
on the display of the indoor unit.
Proceed as described in chapter 9. e) or 9. f).
h) Changing the Bell Tone
• If you briefly push the "
the lower LED (11) lights up yellow.
• You can now use the " " (3) or " " (6) buttons to select a bell tone.
• Save your setting by pushing the "
again.
54
" button again for the display to go out and the indoor
" button (12) at the indoor unit, the camera image appears;
" button (12). The indoor unit is in standby mode
" button (5).
" button (10). The door opener con-
" button is pushed
" button