Firmware Update Via The Module - Miele professional XKM 3100 WCDS Mode D'emploi

Firmware update
via the module
For the update you will need:
– A WPS-enabled router that is connected to the internet.
Switch the washer-disinfector on. After approx. 30 seconds the

module is ready for operation.
Press the button on the module for approx. 3-8 seconds until the

LED begins to flash green.
 Do not press it for any longer than this as this would reset the
module to its factory default settings.
When the button is released the LED lights up steady yellow.
Activate the WPS function on your WiFi router within 120 seconds,

e.g. by pressing the WPS button (if available).
If there is a connection, the LED lights up steady green.
Then press the button again for approx. 18-23 seconds until the

LED begins to flash green.
During the update the LED flashes alternately green and red. After the
update the module carries out a restart. The module starts in AP
mode. The restart is completed when the LED on the module lights
up steady green or yellow.
– Green: The update has completed successfully and the connection
with the tablet has been established.
– Yellow: The update has completed successfully but the connection
with the tablet has not been established. Check whether the tablet
is switched on and the WiFi connection is activated.
en - Operation
43