Replacement - Resus Risycor NV Manuel

■ 10 REPLACEMENT
If a fault occurs, or when the sensor tip has been used up, the probe
must be replaced.
The corrosion monitor can be easily dismantled without having to de-
pressurise the complete installation.
1. Remove the mains adaptor.
2. Remove the tie wrap.
3. Turn the lever of the lockshield valve device perpendicular relative
to the piping so that the expansion vessel of the installation is
closed off.
CAUTION! The green logger will rise up a bit because of the
pressure. Leave the logger in this position!
EN
41