Troubleshooting Guide - Whirlpool ACM 723 Mode D'emploi

Max. operation time
If the user forgets to switch the hob off, it switches off automatically after a given period of time from when the last hotplate was switched on. See the following table.
Selected power Max. operation time (in hours)
0
1
2
3
4
5
When this occurs, if the glass is hot enough, the residual heat indicator "H" appears on the corresponding zone power display.
CLEANING
WARNING
IMPORTANT: Do not use abrasive sponges or scouring pads. Their use could eventually ruin the glass.
• After each use, clean the hob (when it is cool) to remove any deposits and stains due to food residuals.
• Sugar or foods with a high sugar content damage the hob and must be immediately removed.
• Salt, sugar and sand could scratch the glass surface.
• Use a soft cloth, absorbent kitchen paper or a specific hob cleaner (follow the Manufacturer's instructions).

TROUBLESHOOTING GUIDE

• Read and follow the instructions given in the section "Instructions for use".
• Make sure there is not a power outage.
• Dry the hob thoroughly after cleaning it.
• If the hob cannot be switched off after using it, disconnect it from the power supply.
ERROR CODE
The hob switches off and after 30 seconds
emits an acoustic signal every 10 seconds.
A zone switches off and the indicator shows
the message "C82".
AFTER-SALES SERVICE
Before contacting the After-sales Service:
1. See if you can solve the problem yourself with the help of the "Troubleshooting guide".
2. Switch the appliance off and then on again it to see if the problem has been eliminated.
If the problem persists after the above checks, contact the nearest After-Sales Service.
Always specify:
• a brief description of the fault;
• the product type and exact model;
• the Service number (the number after the word Service on the rating plate), located under the appliance (on the metal plate). The Service number is also given in the
warranty booklet;
• your full address;
• your telephone number.
If any repairs are required, contact an authorised After-Sales Service Centre (to ensure the use of original spare parts and correct repairs). Spare parts are available for 10
years.
8
8
5
4
4
3
- Do not use steam cleaners.
- Before cleaning, make sure the cooking zones are switched off and that the residual heat indicator ("H")
is not displayed.
DESCRIPTION
Permanent pressure on the control zone. Water or kitchen utensils on the control
Overtemperature.
Attach here one of the two stickers giving the
product data, included in the warranty booklet.
Selected power
6
7
8
9
P
POSSIBLE CAUSES
zone.
The internal temperature of electronic
parts is too high.
GB10
Max. operation time (in hours)
3
2
2
1
10 minutes
ERROR ELIMINATION
Clean the control zone.
Wait for the hob to cool down before
using it again.